User Manual

ENGLISH
8 BEFORE YOU OPERATE THE MONITOR
CONNECTING YOUR MONITOR
Ensurethatboththecomputerandthemonitorareswitchedo󰀨.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
ConnectthemonitorcabletotheRemoteControlTouchV01(option),ifnecessary.
Connect theACAdaptertothemonitor and thePowerCabletotheAC Adapter rstandthen
connect to the power source.
Turn on your monitor and computer.

Makesurethatthebuildinginstallationhasacircuitbreakerof120/240V,20A(maximum).

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regionaliiyamao󰀩ce.

MakesureyoutightenthengerscrewsateachendoftheSignalCable.

The Class I pluggable equipment Type A must be connected to protective earth.

The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
<Back>
NOTE
Power Cable
(Accessory)
Computer
VGA Cable (Not included)*
DisplayPort Cable (Accessory)
USB Cable (Accessory)
AC Adapter
(Accessory)
Remote
Control
Touch V01
(option)
HDMI Cable (Accessory)
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.