Owner's Manual

ENGLISH
BEFORE YOU OPERATE THE MONITOR 7
CONNECTING YOUR MONITOR
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the monitor to the audio equipment with the Audio Cable for computer when using the audio
features.
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor and computer.

The signal cables used for connecting the computer and monitor may vary with the type of
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama
offi ce.

For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.

Make sure you tighten the fi nger screws at each end of the Signal Cable.
[Example of Connection]
[Collect Cables]
Put the cables through the cable holder and holes.
Collect cables at the back of the stand.
Cable Holes
Cable Holder
Power Cable (Accessory)
Audio Cable (Accessory)
Computer
D-Sub Signal Cable (Accessory)
DVI-D Signal Cable (Accessory)
USB Cable (Accessory)
<Back>
NOTE