Use and Care Manual
10
Figure 3
Lay the door on a protected surface and ensure that the door seal does not get damaged.
Remove door screw ⑧ and limit block ⑦.
Install the limit block ⑦ into the corresponding hole on the other side of the door and affix
the door screw ⑧.
Figure 2
Remove the bottom hinge screw ⑩, short front foot
⑪,
and long front foot ⑫.
Remove the bottom hinge ⑨.
Figure 4
Install the bottom hinge into the corresponding hole on the other side (left side) of the wine
cooler.
Install the bottom hinge screw
⑩
and Short front foot ⑪.
Install the long front foot into the corresponding hole on the other side (right side) of the wine
cooler.
Install the limit block ⑦ into the bottom hinge ⑨ shaft.
Remove the upper hinge screw ④ and left-upper hinge ③.
Turn the left-upper hinge ③ over and insert the shaft into the corresponding shaft hole of the
door, then affix the upper hinge screw ⑤.
Install the right-upper hinge ⑥ in the axial upward direction and affix the upper hinge screw
④.
Figure 5
Insert the top cover ② into the corresponding slot.
Press the rear part down into place and affix the top cover screw ① to complete.
Note: The height of the two-door feet is different, do not install them in the wrong
position when changing the door.