Installation Instructions

www.desatech.com
108319-01D
7
11. Attach the terminal end of the green power cord
wire to the front tab of the blower housing using
screw provided (see Figure 14, page 6).
12. Using the four screws previously removed,
mount blower assembly to stove by reat-
taching blower brackets to rear panel (see
Figure 16). Tighten screws securely.
13. Install plastic control knob onto output shaft of
speed control housing (see Figure 17). Place
speed control housing just inside control com-
partment door in front of stove (see Figure 17).
14. Using two screws provided in blower kit,
mount blower speed control housing to mount-
ing tab in left side of lower control compart-
ment (see Figure 18).
INSTALLING BLOWER
ACCESSORY IN MODEL
SVFBC FREESTANDING
STOVE
Continued
Figure 16 - Removing Blower Brackets
from Stove and Attaching to Blower
Blower
Blower Bracket
Firebox
Top
Figure 17 - Installing Blower Control
Housing
Power
Cord
Speed
Control
Housing
Control
Knob
Figure 18 - Routing Power Cord
Blower Speed
Control Housing
Wiring Diagram Decal
Variable
Fan Switch
WhiteWhite
Black
Green
On
110/115
V.A.C.
Blower
Motor
Black
Black Black
Off
120 Vac.
60 Hz. .
78 Amps
WARNING: Never attempt to service heater while it
is plugged in, operating or hot. Burns and electrical
shock could result. Only a qualied service person
should service or repair heater.
If any of the original wire as supplied with the appliance
must be replaced, it must be replaced with 105°C wire or
it’s equivalent.
WARNING: Label all wires prior to disconnec-
tion when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify
proper operation after servicing.
DESA Heating Products, Bowling Green, KY
15. Check to make sure that the power cord is
completely clear of blower wheel and there
are no foreign objects in blower wheel.
16. Carefully replace stove top panel. Align holes
and replace six screws removed in step 1,
page 6.
17. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the stove oor
as shown in Figure 18.
18. Plug power cord into a convenient 3-prong
grounded wall receptacle near the stove.
WARNING: Electrical Ground-
ing Instructions: This appliance
is equipped with a three-prong
(grounding) plug for your protec-
tion against shock hazard and
should be plugged directly into
a properly grounded three-prong
receptacle.