Installation Instructions

www.desatech.com
108319-01D 3
Figure 4 - Installing Plastic Bushing for
Power Cord
Plastic
Bushing
9. Plug in blower power cord.
a. If your rebox is installed as a freestand-
ing unit, determine whether the power cord
will exit the left side or the right side of the
rebox. Install 1 plastic bushing provided
into the 1
1
/
2
" hole in the oor support on
the exit side. Install the second plastic
bushing provided into the 1
1
/
2
" hole in the
outer casing through which the power cord
will exit (see Figure 4). Route power cord
through both plastic bushings and plug the
power cord into a 3-prong grounded wall
receptacle near the rebox.
b. If your rebox installation is recessed
and/or pre-wired, plug the power cord into
the duplex outlet provided. Refer to your
rebox owner’s manual for instructions on
wiring the duplex outlet.
CAUTION: Never touch the
blower wheel while in operation.
10. Turn on power to duplex outlet if previously
turned off per the warning in step 1, page 2.
11. Check to make sure that the power cord is com-
pletely clear of the blower wheel and that there
are no other foreign objects in blower wheel.
Turn blower on and check for operation.
12. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the rebox
bottom approximately 12" in front of the
blower.
13. Replace bottom of rebox. Note: Make sure
the back of the rebox bottom slides under
the rear of the rebrick (lift the rebrick up if
necessary.)
INSTALLING BLOWER
ACCESSORY IN A 32"
FIREBOX Continued
Figure 5 - Removing Firebrick Floor from
Firebox
Firebrick Floor
14. Reattach rebox bottom using 4 screws re-
moved in step 1, page 2. Note: Discard the
remaining hardware items.
15. Install the log set heater according to the instal-
lation instructions supplied with the heater.
OPERATING THE BLOWER
Light your gas appliance with the blower off. After
about 15 minutes, turn the blower on to deliver
heated air at the top louvers. The blower features
a variable control which allows you to select the
speed you desire.
Note: Periodically check the louvers of the rebox
and remove any dust, dirt or other obstructions.
INSTALLING BLOWER
ACCESSORY IN 36" OR
42" FIREBOX
NOTICE: If a log set is installed
in the rebox, disconnect log
set from gas supply and remove
from rebox. Contact a qualied
service person to do this.
Note: Appearance of rebox may vary depending
on model.
1. If firebrick is installed, carefully lift and
remove the concrete rebrick oor from the
rebox (see Figure 5). Some model reboxes
require that you remove the side and rear
panels rst. Follow the directions below to
remove the side and rear rebrick panels for
those reboxes.