Installation Instructions

www.desatech.com
108319-01D
13
b. If your replace system installation is
recessed and/or pre-wired, a qualified
installer must make all electrical connec-
tions for the outlet kit included with the
replace.
11. Check to make sure that the power cord is
completely clear of the blower wheel and that
there are no other foreign objects in blower
wheel. Turn blower on and check for opera-
tion. Turn blower off by rotating knob fully
counterclockwise before continuing.
CAUTION: Never touch the
blower wheel while in operation.
12. Peel off the backing paper and stick the sup-
plied wiring diagram decal on the outer casing
bottom approximately 3" to the right of the
blower speed control (Figure 28).
WARNING: Failure to position
the parts in accordance with sup-
plied diagrams or failure to use
only parts specically approved
with this heater may result in
damage or personal injury.
13. Connect or reconnect gas supply following
instructions given in the owner’s manual
supplied with your replace.
WARNING: A qualified
service person must connect
replace to gas supply. Follow
all local codes.
INSTALLING BLOWER
ACCESSORY IN DIRECT-
VENT FIREPLACE SERIES
BHDV, (E)BDV, DDV, HDV,
CDV, CHDV, DVF(E) OR
DVFH
Continued
Figure 28 - Installing Plastic Bushing
for Power Cord and Locating Wiring
Diagram Decal
Plastic
Bushing
Wiring
Diagram Decal