Installation Instructions

www.desatech.com
108319-01D
11
7. Place speed control on left inside of rear cover
and push the plastic control shaft through
opening (see Figure 25).
8. While supporting speed control, secure control
shaft with lock nut by pushing and turning lock
nut with pliers clockwise until tight against the
side of rear cover. Place control knob provided
onto shaft (see Figure 25).
9. Plug in blower power cord.
10. Check to make sure that the power cord is
completely clear of the blower wheel and that
there are no other foreign objects in blower
wheel. Turn blower on and check for opera-
tion. Turn blower off by rotating knob fully
counterclockwise before continuing.
CAUTION: Never touch the
blower wheel while in operation.
11. Peel off the backing paper and stick the supplied
wiring diagram decal on the inside of rear cover
as shown (see Figure 25).
12. Connect or reconnect gas supply following
instructions given in the owner’s manual
supplied with your replace.
WARNING: A qualified
service person must connect
replace to gas supply. Follow
all local codes.
13. Reattach bottom cover to rear cover with 8
screws (see Figure 25). Make sure that you
don’t pinch any wires during reassembly.
14. Secure rear cover to back of stove chassis (see
Figure 25).
15. Plug in the power cord when ready to use.
WARNING: Failure to position
the parts in accordance with sup-
plied diagrams or failure to use
only parts specically approved
with this heater may result in
damage or personal injury.
Blower
Assembly
Mounting
Screws
(Included in
Hardware
Pack)
Blower
Control
Knob
Control
Shaft
Rear Cover
Speed
Control
Power
Cord
Lock Nut
Wiring
Diagram
Decal
Screw
Exhaust Port
Green
Ground Wire
Figure 25 - Installing Optional Blower
Accessory
INSTALLING BLOWER
ACCESSORY IN
FREESTANDING STOVE
SERIES SDV, MSD, MSTD,
CDV OR CSDBN
Continued
OPERATING THE BLOWER
Light your gas appliance with the blower off. After
about 15 minutes, turn the blower on to deliver
heated air through the openings in the top of the
stove body. The blower features a variable control
which allows you to select the speed you desire.
The blower helps distribute heated air from the
replace. Periodically check the openings of the
stove top and remove any dust, dirt or other ob-
structions that will hinder the ow of air.