Computer Speaker System for iPhone/iPod User Manual

Listening to non-docking iPhone/iPod or other audio devices

1. Plug one end of an audio cable (available at www.ihomeaudio.com) into the headphone or line-out jack on your device

and the other end of the patch cord into the iP71 Aux-in Jack.

2. Press the button on the right speaker to turn the iP71 on.

3. Press the or Buttons on the right speaker to adjust the system volume. You may need to adjust your device volume,

too.

4. To turn off the iP71, press the button on the right speaker. Please remember to turn off your device, too.

The iP71 allows you to sync your docked iPhone or iPod with a computer directly from the iP71 without removing the iPhone

or iPod.

1. Plug the USB cable into a powered USB port on your computer and the other end to the iP71’s USB port located on the

back of the left speaker.

2. Make sure the iPhone or iPod is properly docked. Press the Sync Button located on the top of the left speaker. A green

LED on the top of the left speaker will light up to indicate computer sync mode is active. The unit will take a few seconds

to start syncing with iTunes. When an iPhone or iPod is syncing, DO NOT undock your iPhone/Pod or press the Sync

Button. During computer sync mode, you cannot control your iPhone or iPod through the iP71 remote.

3. Once syncing is completed, you must eject your iPhone/iPod through iTunes before pressing the Sync Button

to exit sync mode.

Syncing your iPhone/iPod to a Computer through iP71

When an iPhone or iPod is syncing, DO NOT undock your iPhone/iPod

or press the Sync Button