User guide

5
USING LINE-IN
LINE-IN JACK
Connect one end of a standard stereo 3.5mm audio cable (not included)
into the line-in jack on the back of the unit and the other into the
headphone or output jack of your audio device. Press the Power Button
on the unit to turn it on. Press and release the Mode Button as needed
to access iPod mode. Turn the aux device on and press play. Adjust
volume on your audio device and the unit as needed. Do not play a
line-in audio device and a docked iPhone or iPod at the same time or
you will hear both sources.
FM RADIO
Press and release the Mode Button as needed to access FM Radio
mode. Turn the FM Radio Tuner Knob to tune in the desired station.
The unit has an internal FM radio antenna; you may wish to adjust the
unit’s location for better FM reception. For the best reception, insert the
FM Antenna plug into the Aux-in/FM Antenna Jack on the back of the
unit. Extend the wire antenna fully. Do not strip, alter or attach to other
antennas.
USING FM RADIO IN OTHER COUNTRIES
Different areas of the world use different FM frequency steps and
ranges. By default, this unit is set to USA frequency steps. To use the
radio outside the USA, press and hold the Mode Button until USA
appears in the display. Turn the FM Radio Tuner Knob to cycle to your
location: Europe, Japan, Australia, China or USA. Press the Mode
Button to exit frequency setting mode.
4
iPHONE & iPOD
Docking & Charging your iPhone or iPod
Make sure your iPod/iPhone’s firmware is up to date via iTunes before
use. Remove your iPod/iPhone from case or skin before docking. If
necessary, first slide the Docking Retention Bar upwards, then carefully
dock your iPod/iPhone onto the dock. Slide the Docking Retention Bar
down to secure your iPhone/iPod. (Smaller iPod models such as iPod nano
do not require the retention bar.) When unit is connected to power with the
AC adaptor, your iPhone or iPod will charge while docked. It will not
charge when operating on batteries.
Listening to iPhone or iPod
Press the Power Button to turn the unit on. Press the Mode Button to
cycle to iPod mode. Press the Button on the unit to listen to music.
Adjust levels with Volume Knob and adjust the tone with the Graphic
Equalizer Buttons. Press the SRS Button to activate SRS TruBass audio.
In iPod mode, turning the Tuning Knob will adjust the display brightness.
When you are done listening, press the Power Button to turn the unit off.
When unit is off, docking an already playing iPhone or iPod will turn it on.
Push down
USA-Nov 11, 2011