Model iH82 The Portable System For Your iPod® Questions? Visit www.ihomeaudio.
Table of Contents Caution Information ........................................................................................................................................................ 1 Quick Start ....................................................................................................................................................................... 2 Controls and Indicators .................................................................................................................
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
iH82 quick start 1: power: AC or batteries 2: Extension Speaker 3: inserts ext. speaker To charge and play iPod, attach AC adaptor plug to jack on back of the main unit and plug the other end into a working AC outlet. For portable play, open battery door located on the bottom of the iH82. Install 8 “C” batteries (match + and polarity in diagram). Connect the main unit & external speaker using included speaker cable.
Controls and Indicators Main Unit Top Panel Dock Volume Down Button Power On/Off (Play) Button Volume Up Button Main Unit Rear Panel ext.
Installing/Replacing iH82 Batteries Installing/Replacing Batteries 1. Open the battery compartment cover located on the bottom of the main unit. 2. Insert 8 “C” batteries, checking that the + and – ends of the batteries match the drawing inside the battery compartment. We recommend the use of alkaline batteries for longer life. 3. Close the compartment cover. Batteries information: • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Using The Remote Control Power On/Off Button: Turns iH82 ON or OFF Play/Pause Button : Plays track.
Using the iH82 Charging your iPod Note: Please make sure you are using the correct insert for your iPod (see Placing iPod Insert) and that it is properly docked into the main unit. Failure to do so may damage your iPod. 1. While your iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. Your iPod will not charge when operating on battery power. Note that other non-docking iPods will NOT charge. Listening to iPod 1.
Using the iH82 Listening to non-docking iPod or other portable audio devices If you are using an iPod without a docking port or other MP3 player or audio device, you can play it through the iH82 via the Line-in Jack. 1. Plug one end of the audio patch cord (included) into the headphone or line-out jack on your audio device and the other end of the patch cord into the iH82 Line-in Jack located on the back of the main unit. Using iH82 as a PA/Karaoke system The iH82 includes a PA/Karaoke feature.
Troubleshooting Symptom Unit not responding (no power) Possible Problem Solution AC adaptor isn’t plugged to a wall outlet or the connector is not plugged into the power supply jack on the back of the unit Make sure the AC adaptor is plugged into a working AC outlet and connected properly to the back of the iH80.
Troubleshooting Symptom iPod didn’t charge up Possible Problem Solution iPod is not docked properly Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock. iPod is locked up/ frozen Please make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for details. iPod battery has problem The iH80 only charges your iPod while connected to the AC adaptor (not on batteries).
Solucionando problemas Síntoma La unidad no funciona (no circula corriente eléctrica) Causa Solución El adaptador de AC no está conectado al tomacorriente o el conector no está conectado a la ficha en la parte posterior de la unidad Conecte el adaptador de AC al tomacorriente y también conecte el conector a la ficha en la parte posterior de la unidad El tomacorriente no funciona Coloque otro aparato en ese mismo tomacorriente para confirmar si el que no funciona es el tomacorriente Las baterías están
Solucionando problemas Síntoma El iPod no carga Causa Solución El iPod no está instalado correctamente Quite el iPod del encastre y retire la posible obstrucción del encastre o de su iPod. Vuelva a colocar el iPod dentro del encastre. El iPod está trabado/no responde Por favor asegúrese de que su iPod funcione correctamente antes de colocarlo en el encastre. Refiérase al manual de su iPod para mayor información.
A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16.
Limited 90-Day Warranty Information iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI Technologies), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased.
