Operation Manual

Gives a quick but fuel efficient route based on the fuel consumption

data given in Route settings (page 95). Travel cost and CO

emission

calculations are estimations only. They cannot take elevations, curves

and traffic conditions into account.

For vehicle types where Green routing is not available, this method

combines the benefits of Fast and Short: The software calculates as if

it were calculating the Fast route, but it takes other roads as well to

save fuel.

Results in a route with fewer turns and no difficult manoeuvres. With

this option, you can make your software to take, for example, the

motorway instead of a series of smaller roads or streets.

6.3.5 Map settings

You can fine-tune the appearance of the Map screen. Adjust the map view to your needs,

choose suitable colour themes from the list for both daytime and night use, change the blue

arrow to a 3D car model, show or hide 3D buildings, turn track logging on or off, and manage

you Place visibility sets (which Places to show on the map).

The map is always shown on the screen so that you can see the effect when you change a

setting.

Button Description

Switch the map view between a 3D perspective view and a 2D top-

down view.

djust the basic zoom and tilt levels to your needs. Three levels are

available.

When selected, the map zooms out to show an overview of the

surrounding area if the next route event (manoeuvre) is far. When you

get close to the event, the normal map view returns.

Switch between daytime and night colour modes or let the software

switch between the two modes automatically a few minutes before

sunrise and a few minutes after sunset.