User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
5 Starting up
Create all connections while the device is o. Use the shortest possible high-quality
cables for all connections. Take care when running the cables to prevent tripping
hazards.
Connect the DMX input of the device to the DMX output of a DMX controller or
another DMX device. Connect the output of the rst DMX device to the input of the
second one, and so on to form a daisy chain. Always ensure that the output of the
last DMX device in the daisy chain is terminated with a resistor (110 Ω, ¼ W).
When you congure a group of devices in master/slave mode, the rst unit will con‐
trol the other units. This function is ideal when you want to start a show immediately.
Connect the DMX output of the master device to the DMX input of the rst slave
device. Then connect the DMX output of the rst slave device to the DMX input of
the second slave device and so on.
Please note that this device must not be connected to a dimmer.
Connections in DMX mode
Connections in master/slave mode
Starting up
12
Xo8 LED Fx Strobe IP65 800W
stroboscope