User manual

This setting is only relevant if the device is controlled via DMX or ArtNet.
Press [MENU] and use the buttons [UP] and [DOWN] to select the ‘Channel Mode’ option. Con‐
rm with [ENTER] to open the ‘ Channel Mode ’ menu.
Use [UP] or [DOWN] to select the desired channel ‘10CH’ or ‘55CH’ for DMX or channel
‘4x480CH’ for ArtNet and press [ENTER] to conrm the new setting.
There are two modes for controlling via ArtNet. In the single pixel mode (4x480CH S) every
pixel of the 80 or 40 pixels of the Stagepix Line can be controlled. In the double pixel mode
(4x480CH D) two adjacent pixels are controlled in parallel. This is helpful if you need higher
luminous power or if the number of channels should be low while operating the same number
of bars. Keep in mind that the maximum number of bars per output can be dierent.
With [MENU] you return to the previous menu level.
This menu oers you the option to display the currently installed software version.
Press [MENU] and use the buttons [UP] and [DOWN] to select the ‘Software Version’ option.
Conrm with [ENTER] to display the version information.
With [MENU] you return to the previous menu level.
Channel assignment
Software info
Operating
Stagepix Brain IP
29
controller