User manual

Press [Mode] repeatedly until the display shows ‘AUTO’ . The unit now operates in automatic
stand-alone mode.
Press [Mode] repeatedly until the display shows ‘Pro’ . Press [Setup] to then select with [Up] |
[Down] one of the programmes ‘Pr.01’ ‘Pr.28’ .
If you select ‘Pr.01’ you can press [Setup] and then call up with [Up] | [Down] one of 50 pro‐
grammed colour patterns which will then light up constantly (display shows ‘CO.01’
‘CO.50’ ). Press [Setup] to then adjust with [Up] | [Down] the strobe frequency between ‘FL.01’
(slow) and ‘FL.99’ (fast). Select ‘FL.00’ for constant light.
Programmes ‘Pr.02’ ‘Pr.28’ oer preprogrammed colour sequences. After selecting one of
these programmes, press [Setup] to then select with [Up] | [Down] the speed of the colour
sequences from ‘SP.01’ (slow) to ‘SP.FL’ (fast). Press [Setup] to then adjust with [Up] | [Down]
the strobe frequency between ‘FL.01’ (slow) and ‘FL.99’ (fast).
Press [Mode] repeatedly until the display shows ‘d---’ . Press [Setup] to then select with [Up] |
[Down] the desired DMX address between 1 and 512 (the display shows ‘d.001’ ‘d.512’ ).
Make sure that this number matches the conguration of your DMX controller.
Press [Setup] to then select with [Up] | [Down] the number of channels (9, 14, 17, 81, 83 or 98)
available for DMX operation.
Auto mode
Programme mode
DMX address
Operating
28
Magic Cube 3D
eect panel