User manual

Connect the DMX input of the device to the DMX output of a DMX controller or other DMX
device. Connect the output of the rst DMX device to the input of the second one and so on,
to form a series connection.
Such a chain may consist of up to 30 DMX devices. Make sure that the output of the last device
in the chain is terminated by a resistor (110 Ω, ¼ W).
With active display, a dot is lit in the rst digit when the unit is in DMX mode. If the dot is not
lit, no valid DMX data is received.
Connections in ‘DMX’ mode
Installation and starting up
Magic Cube 3D
21
eect panel