User manual

Linear
0
0 %
100 %
255
ö
#
Square
0
0 %
100 %
255
ö
#
Inv Square
0
0 %
100 %
255
ö
#
S-Type
0
0 %
100 %
255
ö
#
Press [Mode] repeatedly until the display shows ‘SEt’ . [Setup]. Use [Up] | [Down] to select the
menu item ‘Rst’ and conrm with [Setup]. Use [Up] | [Down] choose between ‘Yes’ (carry out
reset) and ‘No’ (no reset) and conrm with [Setup].
Press [Mode] repeatedly until the display shows ‘SEt’ . [Setup]. Use [Up] | [Down] to select the
menu item ‘FAIL’ and conrm with [Setup]. With [Up] | [Down] you can choose how the device
behaves in case of a disturbed DMX transmission: ‘HoLd’ (the current state is retained) and
‘O’ (device blackout). Conrm the selection with [Setup].
Press [Mode] repeatedly until the display shows ‘SEt’ . [Setup]. Use [Up] | [Down] to select the
menu item ‘SYNC’ and conrm with [Setup]. With [Up] | [Down] you can choose how connected
devices behaves in case of a disturbed DMX transmission: ‘ON’ (devices are synchronised with
each other) and ‘O’ (no synchronisation). Conrm the selection with [Setup].
Reset
Behaviour on DMX failure
DMX synchronisation
Operating
26
Magic Cube 3D
Eect Panel