User manual

Press [Mode] or [Up] | [Down] repeatedly until the display shows ‘Colr’ . Press [Setup]. You can

now adjust the intensity of red, green and blue of the LEDs in three segments successively in a

range from 0 bis 100 %:

n Display shows ‘r1.00’ … ‘r1.FL’ : Intensity red (0 % to 100 %), segment 1

n Display shows ‘g1.00’

… ‘g1.FL’ : Intensity green (0 % to 100 %), segment 1

n Display shows ‘b1.00’ … ‘b1.FL’ : Intensity blue (0 % to 100 %), segment 1

n Display shows ‘r2.00’

… ‘r2.FL’ : Intensity red (0 % to 100 %), segment 2

n Display shows ‘g2.00’ … ‘g2.FL’ : Intensity green (0 % to 100 %), segment 2

n Display shows ‘b2.00’

… ‘b2.FL’ : Intensity blue (0 % to 100 %), segment 2

n Display shows ‘r3.00’ … ‘r3.FL’ : Intensity red (0 % to 100 %), segment 3

n Display shows ‘g3.00’

… ‘g3.FL’ : Intensity green (0 % to 100 %), segment 3

n Display shows ‘b3.00’ … ‘b3.FL’ : Intensity blue (0 % to 100 %), segment 3

Press [Mode] repeatedly until the display shows ‘Soud’ . The device now shows a sound-con‐

trolled colour sequence. Press [Setup] to then select with [Up] | [Down] the sensitivity of the

built-in microphone for sound control between ‘SU.00’ (low) and ‘SU.31’ (high).

Color mode

Sound mode

Operating

Magic Cube 3D

Eect Panel