User manual

Press [Mode] repeatedly until the display shows ‘Pro’ . Press [Setup] to then select with [Up] |
[Down] one of the programmes ‘Pr.01’ … ‘Pr.28’ .
If you select ‘Pr.01’ you can press [Setup] and then call up with [Up] | [Down] one of 50 pro‐
grammed colour patterns which will then light up constantly (display shows ‘CO.01’ …
‘CO.50’ ). Press [Setup] to then adjust with [Up] | [Down] the strobe frequency between ‘FL.01’
(slow) and ‘FL.99’ (fast). Select ‘FL.00’ for constant light.
Programmes ‘Pr.02’ ‑ ‘Pr.28’ oer preprogrammed colour sequences. After selecting one of
these programmes, press [Setup] to then select with [Up] | [Down] the speed of the colour
sequences from ‘SP.01’ (slow) to ‘SP.FL’ (fast). Press [Setup] to then adjust with [Up] | [Down]
the strobe frequency between ‘FL.01’ (slow) and ‘FL.99’ (fast).
Press [Mode] repeatedly until the display shows ‘d---’ . Press [Setup] to then select with [Up] |
[Down] the desired DMX address between 1 and 512 (the display shows ‘d.001’ … ‘d.512’ ).
Make sure that this number matches the conguration of your DMX controller.
Press [Setup] to then select with [Up] | [Down] the number of channels (9, 14, 17, 81, 83 or 98)
available for DMX operation.
Press [Mode] repeatedly until the display shows ‘SLAv’ . The device is now working in slave
mode, i.e. it will exactly copy the movement of the controlling master device, correct wiring
provided.
Programme mode
DMX address
Slave mode
Operating
Magic Cube 3D
23
Eect Panel