User manual

1. Press [Mode] and use [Up] or [Down] to select the menu item ‘DMX’ . Conrm with

[Setup].

2. Use [Up] or [Down] to select a value between ‘Address 001’ and ‘Address 512’ to set the

DMX address.

3. Press [Setup] to accept the selection.

4. Use [Up] or [Down] to select the desired DMX mode (1 or 2 channels). Depending on the

selected mode, the display shows ‘1-CH’ or ‘2-CH’ .

5. Press [Setup] to accept the selection.

This setting is only relevant when the device is controlled via DMX. Make sure that this number

matches the conguration of your DMX controller. The following table shows the highest pos‐

sible DMX address for the various DMX modes.

Mode Display Highest possible DMX address

1-channel ‘1-CH’ 512

2-channel ‘2-CH’ 511

When the DMX mode is activated, the display shows ‘Dmx In’ .

DMX address, DMX mode

Operating

ACL LED Par 64

LED PAR