User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 Operating on the unit
- 7.3 Menu overview
- 7.4 Functions in 1-channel DMX mode
- 7.5 Functions in 2-channel DMX mode, variant A
- 7.6 Functions in 2-channel DMX mode, variant B
- 7.7 Functions in 3-channel DMX mode
- 7.8 Functions in 5-channel DMX mode, variant A
- 7.9 Functions in 5-channel DMX mode, variant B
- 7.10 Functions in 9-channel DMX mode
- 7.11 Colour temperature adjustment via DMX
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Symptom Remedy
The unit does not work, no
light.
Check the mains connection and the fuse.
No response to the DMX con‐
troller.
1. Check the DMX ports and cables for proper connection.
2. Check the address settings and the DMX polarity.
3. Try using another DMX controller.
4. Check to see if the DMX cables run near or alongside to
high voltage cables that may cause damage or interfer‐
ence to DMX interface circuits.
If the procedures recommended above do not succeed, please contact our Service Center. You
can nd the contact information at www.thomann.de.
Troubleshooting
74
2bright Pint TW200 IP
LED PAR