User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 Operating on the unit
- 7.3 Menu overview
- 7.4 Functions in 1-channel DMX mode
- 7.5 Functions in 2-channel DMX mode, variant A
- 7.6 Functions in 2-channel DMX mode, variant B
- 7.7 Functions in 3-channel DMX mode
- 7.8 Functions in 5-channel DMX mode, variant A
- 7.9 Functions in 5-channel DMX mode, variant B
- 7.10 Functions in 9-channel DMX mode
- 7.11 Colour temperature adjustment via DMX
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
1. Press [MENU] and then [UP] or [DOWN] repeatedly until the display shows ‘Settings’ .
Conrm with [ENTER].
2. Press [UP] or [DOWN] repeatedly until the display shows ‘DMX Fail’ . Conrm with
[ENTER].
3. Use [UP] or [DOWN] to choose between ‘Hold Last’ , ‘Blackout’ and ‘Manual’ , to make the
setting to be used when the DMX controller fails.
The following sub menus are available:
Menu level 3 Function
‘Hold Last’ The last received signal is held.
‘Blackout’ The spotlight is turned o.
‘Manual’ The device calls up the values set in the ‘Stand Alone’ menu.
4. Press [ENTER] to accept the selection.
Setting the behaviour on DMX
control failure
Operating
34
2bright Pint TW200 IP
LED PAR