User manual
Table Of Contents
- Table of contents
- 1 General information
- 2 Safety instructions
- 3 Features
- 4 Installation
- 5 Starting up
- 6 Connections and controls
- 7 Operating
- 7.1 Starting the device
- 7.2 Operating on the unit
- 7.3 Menu overview
- 7.4 Functions in 1-channel DMX mode
- 7.5 Functions in 2-channel DMX mode, variant A
- 7.6 Functions in 2-channel DMX mode, variant B
- 7.7 Functions in 3-channel DMX mode
- 7.8 Functions in 5-channel DMX mode, variant A
- 7.9 Functions in 5-channel DMX mode, variant B
- 7.10 Functions in 9-channel DMX mode
- 7.11 Colour temperature adjustment via DMX
- 8 Technical specifications
- 9 Plug and connection assignments
- 10 Troubleshooting
- 11 Cleaning
- 12 Protecting the environment
Mode Display Highest possible DMX address
5-channel, variant A ‘5CH A’ 508
5-channel, variant B ‘5CH B’ 508
9-channel ‘9CH’ 504
1. Press [MENU] and then [UP] or [DOWN] repeatedly until the display shows ‘DMX Mode’ .
Conrm with [ENTER].
2. Use [UP] or [DOWN] to select the desired DMX mode (1, 2, 3, 5, or 9 channels). Depending
on the selected mode, the display shows ‘1CH’ , ‘2CH A’ , ‘2CH B’ ‘3CH’ , ‘5CH A’ , ‘5CH B’ or
‘9CH’ .
3. Press [ENTER] to accept the selection.
This setting is only relevant when the device is controlled via DMX.
Setting the DMX mode
Operating
30
2bright Pint TW200 IP
LED PAR