User manual

5. Press [ENTER] to accept the selection.
1. Press [ENTER] and then [UP] or [DOWN] repeatedly until the display shows ‘Slave’ . Con‐
rm with [ENTER].
2. Use [UP] or [DOWN] to select the menu item ‘Yes’ . Conrm with [ENTER].
ð
The device is now working in slave mode, i.e. it will exactly copy the movement of
the controlling master device, correct wiring provided.
3. To disable the W-DMX mode, select ‘No’ . Conrm with [ENTER].
This setting is only relevant if the device is not controlled via DMX.
1. Press [ENTER] and then [UP] or [DOWN] repeatedly until the display shows ‘Settings’ .
Conrm with [ENTER].
2. Press [UP] or [DOWN] repeatedly until the display shows ‘Output Set’ . Conrm with
[ENTER].
3. Use [UP] or [DOWN] to select either ‘Standard’ (output power 150 W) or ‘Full’ (output
power 180 W).
4. Press [ENTER] to accept the selection.
Activating Slave mode
Setting output power
Operating
2bright Par 18 IP
35
LED Spotlight