Operation Manual

96
INSTALLATION
• Install the appliance away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must be
respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Fit the spacers (if supplied) on the rear of the condenser positioned
at the back of the appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm gap above the
appliance and make sure that adjacent kitchen units are sufficiently
distanced to allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is
level, using the front adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical connection
• Electrical connections must be made in accordance with local
regulations.
• Voltage and power consumption are indicated on the rating plate
inside the appliance.
• Regulations require that the appliance is earthed.
The Manufacturer declines all liabilities for injury to persons or
animals or damage to property resulting from failure to observe
these regulations.
• If the plug and socket are not of the same type, have the socket
replaced by a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by
means of a two-pole switch fitted upline of the socket.
60202004GB.fm Page 96 Wednesday, March 22, 2006 4:58 PM