Use and Care Manual

CHANGING THE REVERSIBLE DOOR

CAUTION: To avoid personal injury to yourself and/or property, we recommend someone

assist you during the door reversal process.

Your refrigerator is built with a reversible door. You have the choice of either opening it from the left

or the right side. In order to reserve the opening direction of your door, please follow these simple

instructions:

1) Disassemble all the reversible components in the sequence as shown below (also refer to left

diagram above). Be sure to keep them well for later use in the process of reassembling.

(1) leveling leg II (9) upper door right stopper

(2) bottom hinge (10) door, freezer section

(3) leveling leg I (11) top hinge

(4) bottom door baffle block (12) 2 screws to hold top hinge

(5) 2 screws to hold bottom hinge (13) Door hinge cover

(6) door, refrigerator section (14) Plug

(7) mid hinge (15) upper door left stopper

(8) 2 screws to hold mid hinge

2) To access the bottom hinge assembly, you may tilt back the refrigerator cabinet or lay the

refrigerator on its back.

3) Remove the upper door right stopper (9), install the upper door left stopper (15) on the opposite

side; take down the bottom door baffle block (4), and install it on the opposite side.

4) Reassemble the unit with the door hinges on the opposite side (see the right diagram above).

The sequence for reassembling is just in reverse order of disassembling.

5) With the mid hinge not being fastened too tight, align two doors properly on the cabinet and then

fasten the mid hinge. If necessary, loosen the bottom hinge and the top hinge when aligning and

then fasten them tight.