User Manual
12
Drainage Channel
• The drainage channel must be cleaned regularly to prevent a build-up of impurities; this
can be found on the interior back wall of your appliance.
• Use a damp clean cloth and wipe the channel clean, then use a pipe cleaner or similar
exible object to clean the drainage hole to prevent blockages.
Going away
If you are going away and do not want to leave the appliance left on, switch off at the
mains socket and remove the plug ensuring not to pull the cord. Remove any food and
follow the cleaning instructions in the “Cleaning and Maintenance” section.
Important: Leave the door ajar as this will prevent odours and mould accumulating in
the appliance and will allow the appliance to dry completely.
Power Cut
In the event of a power cut keep the appliance door closed to maintain the temperature
inside.
Operating Sounds
The cooling gas which circulates in the cooling circuit may make a slight noise (bubbling
sound) even when the compressor is not running. Do not worry this is quite normal.
If these sounds are different check that:
• The appliance is well levelled
• Nothing is touching the rear.
• The stuffs on the appliance are vibrating.
Changing the Light
The light is an energy efcient, long life LED. Therefore should not need replacing
throughout the life of the product, however if it does, it is advised to contact a qualied
technician.
1. Remove the light cover
2. Loosen the thermostat knob and fastening screw, and remove the thermostat box
assembly
3. Remove the connector
4. Remove the light