Instructions / Assembly

support@ilters.com
www.ilters.com
Countertop Filtration Systems
CNTP Series
Installation Guide
© Copyright iFilters.com. All Rights Reserved.
V1-0419
To insure your system keeps performing at its best, only use original OEM
Certied lters. Using untested lters will reduce the performance of your
system and void its warranty.
Change your lter every 4 - 6 months (depending on usage and water
quality).
SCAN TO ORDER:
Scan QR Code to purchase
replacement lter
Replacing Your Filter
- Place unit in sink as water will spill.
- Place wrench over housing while
holding the bottom base with your
other hand.
- Turn Housing counter-clockwise to
open.
- A towel may be used to help grip the
bottom part of the unit.
1
Bottom
Grip
Housing
Wrench
- Remove old lter and place new lter.
- Insure the lter catridge is stright and
properly seated to insure a tight seal.
- Insure the O-ring is not damaged and
seated properly. Replace if needed.
- Hand tighten housing clockwise, do
not use wrench or overtighten.
- Flush lter for 5 - 10 minutes. DONE!
2
Stand Pipe
Hold Grip
Clockwise
O-Ring
REPLACEMENT PARTS:
Filter: CBSM-2510
O-Ring: HF2/3-ORING
Diverter Valve: P-DV-14