Instruction Manual

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 54
Step 1: Align the connectors. Make sure that the connectors are lined up correctly.
Step 2: Push straight down until the card is properly seated. Push the card straight
downwards to connect. Use a firm pushing action to connect. When the card is
connected properly, there will be no gaps between the motherboard connector
and the card connector.
Step 3: Secure the PCI-104 expansion card. Secure the PCI-104 expansion card with
two retention screws (
7Figure 4-13).
4.5.6 SATA Drive Connection
The WAFER-CV-D25502/N26002 is shipped with two SATA drive cables. To connect the
SATA drive to the connector, please follow the steps below.
Step 1: Locate the SATA connector and the SATA power connector. The locations of
the connectors are shown in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector and the SATA power connector. See
7Figure 4-14.
Figure 4-14: SATA Drive Cable Connection