Instruction Manual

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 47
4.5.1 AT/ATX Power Connection
Follow the instructions below to connect the WAFER-CV-D25502/N26002 to an AT or
ATX power supply.
WARNING:
Disconnect the power supply power cord from its AC power source to
prevent a sudden power surge to the WAFER-CV-D25502/N26002.
Step 1: Locate the power cable. The power cable is shown in the packing list in
Chapter 2.
Step 2: Connect the power cable to the motherboard. Connect the 4-pin (2x2) Molex
type power cable connector to the power connector on the motherboard. See
7Figure 4-5.
Figure 4-5: Power Cable to Motherboard Connection
Step 3: Connect power cable to power supply. Connect one of the 4-pin (1x4) Molex
type power cable connectors to an AT/ATX power supply. See
7Figure 4-6.