Manual

WAFER-945GSE 3.5" Motherboard
Page 44
Jumper Label: ATXCTL1
Jumper Type:
3-pin header
Jumper Settings:
See Table 4-2
Jumper Location:
See Figure 4-3
The AT Power Select jumper specifies the systems power mode as AT or ATX.
Setting Description
Short 2-3 Use AT power (Default)
OFF Use ATX power
Table 4-2: AT Power Select Jumper Settings
Figure 4-3: AT Power Select Jumper Location
4.4.2 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings:
See
Table 4-3
Jumper Location:
See
Figure 4-4
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device.
Setting Description
OFF Slave (Default)