Owner's manual

UPC-12A/GM45 Panel PC

Page 87

COM1 DEFAULT

System is remotely accessed through COM1

COM2

System is remotely accessed through COM2

COM3

System is remotely accessed through COM3

COM4

System is remotely accessed through COM4

NOTE: Make sure the selected COM port is enabled through the Super I/O configuration

menu.

Î Base Address, IRQ [3F8h,4]

The Base Address, IRQ option cannot be configured and only shows the interrupt

address of the serial port listed above.

Î Serial Port Mode [115200 8,n,1]

Use the Serial Port Mode option to select baud rate through which the console redirection

is made. The following configuration options are available

 115200 8,n,1 DEFAULT

 57600 8,n,1

 38400 8,n,1

 19200 8,n,1

 09600 8,n,1

NOTE:

Identical baud rate setting musts be set on the host (a management

computer running a terminal software) and the slave

Î Redirection After BIOS POST [Always]

Use the Redirection After BIOS POST option to specify when console redirection should

occur.