Owner's manual

UPC-12A/GM45 Panel PC
Page 81
Î
Disabled
Prevents the BIOS from using 32-bit data transfers.
Î
Enabled DEFAULT
Allows BIOS to use 32-bit data transfers on supported
hard disk drives.
6.3.3 Super IO Configuration
Use the Super IO Configuration menu (602H602HBIOS Menu 6) to set or change the
configurations for the FDD controllers, parallel ports and serial ports.
BIOS SETUP UTILITY
Main Advanced PCIPNP Boot Security Chipset Exit
Configure ITE8718 Super IO Chipset
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Serial Port1 Address [3F8/IRQ4]
Serial Port2 Address [2F8/IRQ3]
Serial Port3 Address [3E8]
Serial Port3 IRQ [10]
Serial Port4 Address [2E8]
Serial Port4 IRQ [10]
Select RS232 or RS422/RS485 [BY HARDWARE]
Allows BIOS to select
Serial Port Base
Addresses
ÅÆ Select Screen
↑ ↓ Select Item
Enter Go to SubScreen
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.
BIOS Menu 6: Super IO Configuration
Î Serial Port1 Address [3F8/IRQ4]
Use the Serial Port1 Address option to select the Serial Port 1 base address.
Î
Disabled
No base address is assigned to Serial Port 1
Î
3F8/IRQ4 DEFAULT
Serial Port 1 I/O port address is 3F8 and the interrupt
address is IRQ4
Î
3E8/IRQ4
Serial Port 1 I/O port address is 3E8 and the interrupt
address is IRQ4