Owner's manual

UPC-12A/GM45 Panel PC
Page 56
4.12 Bottom Panel Switch and Connectors
4.12.1 AT/ATX Mode Selection
AT and ATX power modes can both be used on the EP series panel PC. The selection is
made through an AT/ATX switch on the chassis rear panel (
568H568HFigure 4-23). To select AT
mode or ATX mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the chassis rear panel (
569H569HFigure 4-23).
Figure 4-23: AT/ATX Switch
Step 2: Adjust the AT/ATX switch. The default mode is ATX mode (
570H570HFigure 4-23).Step 0:
4.12.2 LAN Connection
There is one external RJ-45 LAN connector. The RJ-45 connector enables connection to
an external network. To connect a LAN cable with an RJ-45 connector, please follow the
instructions below.
Step 1: Locate the RJ-45 connectors on the I/O interface panel of the UPC-12A/GM45
series.
Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of
the RJ-45 connectors on the I/O interface panel of the UPC-12A/GM45 series.
See
571H571HFigure 4-24.