Owner's manual

UPC-12A/GM45 Panel PC
Page 51
Figure 4-17: Mount the Chassis
Step 3: Secure the panel PC with the wall-mounting kit. To do this, stick the protective
cushion to the wall-mounting kit first. Then, put the wall-mounting kit on the top
panel of the panel PC. Carefully mark the location of the wall-mounting kit screw
holes on the wall. Drill a pilot hole at the marked location on the wall. Secure the
wall-mounting kit to the wall by inserting a retention screw into the pilot hole on
the wall (
564H564HFigure 4-18). This step is to avoid the panel PC being pushed apart
from the wall-mounting bracket accidentally. Step 0: