Manual

UPC-12A/GM45 Panel PC
Page 40
4.9.1 Access the Jumpers
To access the jumpers, please remove the rear cover. Please refer to Section 546H546H546H546H546H546H546H548H5.4.3 Step
1~4 for rear cover removal instruction.
4.9.2 Preconfigured Jumpers
WARNING:
Do not change the settings on the jumpers in described here. Doing so
may disable or damage the system.
The following jumpers are preconfigured for the UPC-12A/GM45. Users should NOT
change these jumpers.
Jumper Name Label Type
LVDS voltage selection JP3 6-pin header
Panel Type and Resolution JP1 8-pin header
Table 4-2: Preconfigured Jumpers
4.9.3 CF Voltage Select
Jumper Label:
JP7
Jumper Type:
3-pin header
Jumper Settings:
See
547H547H547H547H547H547H547H549HTable 4-3
Jumper Location:
See
548H548H548H548H548H548H548H550HFigure 4-10
The CF Voltage Select jumper sets the CF Type II slot can be set as either +5 V or +3.3 V.
CF Voltage Select jumper settings are shown in
549H549H549H549H549H549H549H551HTable 4-3.