Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 47
Step 7: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR3 memory module down (Figure 5-7).
Step 8: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR3 memory module in the socket.
Figure 5-7: DDR3 SO-DIMM Module Installation
Step 9: Replace the back cover and secure it using eight (8) previously removed
retention screws.
5.4.3 WLAN Card Replacement
The uIBX-210-CV-N2600 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Remove eight (8) retention screws from the back cover. See Section 5.4.1.
Step 2: Remove HDD module. See Section 5.4.1.
Step 3: Locate the WLAN card.