Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 43
 Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.
5.3 Turn off the Power
WARNING:
Failing to turn off the system before opening can cause permanent
damage to the system and serious or fatal injury to the user.
Before any maintenance procedures are carried out on the system, make sure the system
is turned off.
5.4 Replacing Components
5.4.1 Hard Dis k Drive (HDD) Replacement
To replace the hard drive, please follow the steps below:
Step 1: Remove eight (8) retention screws from the back cover (Figure 5-1).
Figure 5-1: Retention Screws Removal
Step 2: Remove the back cover and locate the HDD bracket (Figure 5-2).