Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 31
Step 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the onboard connector. Step 0:
3.8.7 VGA Monitor Connection
The uIBX-210-CV-N2600 has a single female DB-15 connector on the rear panel. The
DB-15 connector is connected to a CRT or VGA monitor. To connect a monitor to the
uIBX-210-CV-N2600, please follow the instructions below.
Step 1: Locate the female DB-15 connector. The location of the female DB-15
connector is shown in Chapter 1.
Step 2: Align the VGA connector. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the uIBX-210-CV-N2600.
Step 3: Insert the VGA connector. Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
uIBX-210-CV-N2600. See Figure 3-27.
Figure 3-27: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector.