Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 28
Figure 3-23: LAN Connection
Step 3: Insert the LAN cable RJ-45 connector. Once aligned, gently insert the LAN
cable RJ-45 connector into the RJ-45 connector. Step 0:
3.8.4 RS-232Serial Port Connection
There are two RS-232 DB-9 connectors of the uIBX-210-CV-N2600 for serial device
connection. Follow the steps below to connect a serial device to the DB-9 connector of the
uIBX-210-CV-N2600.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in Chapter 1.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the uIBX-210-CV-N2600. See Figure 3-24.