Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 13
Step 2: Install the antennas to the antenna connectors (Figure 3-1).
Figure 3-1: Wi-Fi Antenna Installation
3.4 AT/ATX Mode Selection
AT or ATX power mode can be used on the uIBX-210-CV-N2600. The selection is made
through an AT/ATX switch located on the rear panel (Figure 3-2). To select AT mode or
ATX mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the rear panel (Figure 3-2).
Figure 3-2: AT/ATX Switch Location
Step 2: Adjust the AT/ATX switch. Step 0: