Owner's manual

uIBX-200-VX800 Embedded System
Page 25
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
Pin Description Pin Description
1 DCD 6 DSR
2 RX 7 RTS
3 TX 8 CTS
4 DTR 9 RI
5 GND
Table 4-7: Serial Port Pinouts
Figure 4-12: Serial Port Pinouts
4.4.5 USB Connector
CN Label: USB
CN Type:
USB port
CN Location:
See
Figure 4-5 and Figure 4–6
CN Pinouts:
See
Table 4-8
The USB ports are for attaching USB peripheral devices to the system.
Step 1: Located the USB connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors. See
Figure 4-13.