Manual

UIBX-200-R11/Z510P Embedded System
Page 16
4.2 Jumper Settings
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.
Description Label Type
AT/ATX power select SW1 Switch
Clear CMOS JP1 3-pin header
Table 4-1: Jumpers
4.2.1 AT/ATX Power Switch Settings
Jumper Label: SW1
Jumper Type:
Switch
Jumper Settings:
See
Table 4-2
Jumper Location
See
Figure 4-1
Sets the system power as AT or ATX.