Owner's manual

TANK-820-H61 Embedded System
Page 24
Figure 3-9: Mounting Bracket Retention Screws
Step 3: Secure the brackets to the system by inserting two retention screws into each
bracket (Figure 3-9).
Step 4: Drill holes in the intended installation surface.
Step 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.6 Foot Pad Installation
The TANK-820-H61 is shipped with four foot pads. To install the foot pads, follow the
instructions below.
Step 1: Turn the TANK-820-H61 to the left side panel.
Step 2: Locate the four retention screw holes for the food pad in the bottom surface.
Step 3: Align the hole of the foot pad with the retention screw holes on the bottom
surface.
Step 4: Secure the foot pad to the chassis by inserting the retention screw. Step 0: