User Manual

TANK-820 Embedded System
Page 35
Step 3: Insert the VGA connector. Once the connectors are properly aligned with,
insert the male connector from the VGA screen into the female connector on the
TANK-820. See Figure 3-25.
Figure 3-25: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector.
Figure 3-26: VGA Connector
3.8 Powering On/Off the System
WARNING:
Make sure a power supply with the correct input voltage is being fed into