User Manual

TANK-820 Embedded System
Page 23
Figure 3-8: System Fan Installation
Step 4: Connect the system fan cable to the CPU_FAN1 connector on the motherboard
of TANK-820.
Step 5: Reconnect the SATA signal and power cables to the TANK-820.
Step 6: Reinstall the cover.
3.5 Mounting the System with Mounting Brackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Step 1: Turn the embedded system to the left side panel.
Step 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the bottom surface or the left side panel (Figure 3-9).