User Manual

TANK-800 Embedded System
Page 37
3.7.11 USB Connectors
CN Label: USB
CN Type:
USB port
CN Location:
See
Figure 1-2
CN Pinouts:
See
Table 3-8
The USB ports are for connecting USB peripheral devices to the system.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in
Figure 1-2.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors. See
Figure 3-28.
Figure 3-28: USB Device Connection
Step 3: Insert the device connector. Once aligned, gently insert the USB device
connector into the on-board connector.