User Manual

TANK-800 Embedded System
Page 22
Step 5: Reconnect the SATA signal and power cables to the TANK-800.
Step 6: Reinstall the cover.
3.4 System Fan Installation
To install the optional system fan, please follow the steps below:
Step 1: Loosen the thumbscrew, slide the cover inwards (
Figure 3-4), and then lift the
cover up gently.
Step 2: Unplug the SATA signal and power cables connected to the TANK-800, and then
place the cover on a flat surface (
Figure 3-5).
Step 3: Unscrew the four retention screws that secure the HDD bracket to the cover.
(
Figure 3-8). Remove the HDD bracket from the cover.
Figure 3-8: Remove the HDD Bracket from the Cover
Step 4: Unscrew the four retention screws that secure the fan bracket to the cover.
(
Figure 3-9). Remove the fan bracket from the cover.