Manual

TANK-800 Embedded System
Page 32
3.7.10 RS-232 Serial Port Connectors
CN Label:
COM1, COM2, COM3 and COM4
CN Type:
DB-9 connectors
CN Location:
See
Figure 1-2
CN Pinouts:
See
Table 3-6 and Figure 3-21
RS-232 serial port devices can be attached to the DB-9 ports on the rear panel.
Step 1: Locate the DB-9 connector. The locations of the DB-9 connectors are shown
in
Figure 1-2.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
Figure 3-20.
Figure 3-20: Serial Device Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.