Manual

TANK-800 Embedded System
Page 24
3.6 Mounting the System with Mounting Brackets
To mount the embedded system onto a wall or some other surface using the two mounting
brackets, please follow the steps below.
Step 1: Turn the embedded system over.
Step 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the side panel.
Step 3: Secure the brackets to the system by inserting two retention screws into each
bracket.
Step 4: Drill holes in the intended installation surface.
Step 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 6: Insert four retention screws, two in each bracket, to secure the system to the
wall.
3.7 External Peripheral Interface Connectors
The TANK-800 has the following connectors. Detailed descriptions of the connectors can
be found in the subsections below.
 Audio
 CompactFlash® Type II
 DIO
 Ethernet
 Power button
 Power input
 Reset button
 RS-232
 RS-422/485
 USB
 VGA