Instruction Manual

TANK-700 Embedded System
Page 60
 Device Mode [Normal]
Use the Device Mode option to enable or disable the serial port.

Normal DEFAULT
Sets the serial port mode to normal.

RS422/485
Enables serial port RS-422/485 support.
4.3.6.1.2 Serial Port 8 Configuration
 Serial Port [Enabled]
Use the Serial Port option to enable or disable the serial port.

Disabled
Disable the serial port

Enabled DEFAULT
Enable the serial port
 Change Settings [Auto ]
Use the Change Settings option to change the serial port IO port address and interrupt
address.

Auto DEFAULT
The serial port IO port address and interrupt address
are automatically detected.

IO=2F8h;
IRQ=3
Serial Port I/O port address is 2F8h and the interrupt
address is IRQ3

IO=3F8h;
IRQ=3, 4, 5,
6, 7, 9, 10,
11, 12
Serial Port I/O port address is 3F8h and the interrupt
address is IRQ3, 4, 5, 6, 7, 9, 10, 11, 12

IO=2F8h;
IRQ=3, 4, 5,
6, 7, 9, 10,
11, 12
Serial Port I/O port address is 2F8h and the interrupt
address is IRQ3, 4, 5, 6, 7, 9, 10, 11, 12